TABLE OF CONTENTS

• SEQTA Kiosk - enabling or disabling Attendance types
  • Enabling an Attendance type in SEQTA Kiosk
    • SEQTA Kiosk Version 6 and Above
    • SEQTA Kiosk Version 5 or Below

SEQTA Kiosk - enabling or disabling Attendance types

Support documentation for the Attendance types for SEQTA Kiosk is available in the Kiosk Manual, which you can download from the article: Introduction to SEQTA Kiosk (full manual) . Once the Attendance type has been created, it will need to be enabled in the SEQTA Kiosk settings on the iPad. See steps below.

Enabling an Attendance type in SEQTA Kiosk

SEQTA Kiosk Version 6 and Above

1. Open SEQTA Kiosk on the iPad.
2. Click on the cog icon in the top-right of the login page in SEQTA Kiosk.
3. Enter the Admin PIN
4. Scroll down to Reset data, then tap on Reset attendance types.
5. Choose Yes to sync the iPad with the attendance types from SEQTA Teach. This will replace all existing Attendance types in the iPad.
   1. Please note the iPad will only pick-up Attendance types which have the same Mode as the Kiosk settings on the iPad (ie: Campus or Class). To check the mode for an Attendance type go to the Administration Workspace>Attendance administration>Type Manager in SEQTA Teach.
6. Select the applicable Attendance types and set the slider to disable that type so that it does not appear on that iPad.
7. Select Done to save the changes.

SEQTA Kiosk Version 5 or Below

Close then open SEQTA Kiosk or restart the iPad.